Install guide

How to install a 40 A home EV charger.

The Portal 40A plugs into a NEMA 14-50 receptacle on a dedicated 50 A two-pole breaker. Here is what the installation involves.

Use a licensed electrician. Installing a 240 V circuit is not a DIY job. Installation by a licensed electrician, to your local code, is required for the warranty.

The short answer

Have a licensed electrician install a NEMA 14-50 receptacle on a dedicated 50 A two-pole breaker, typically with 6 AWG copper wire, then mount the charger and plug it in. The circuit is sized at 125% of the charger's 40 A because EV charging counts as a continuous load under the National Electrical Code: 40 A × 1.25 = 50 A.

Step by step

  1. Confirm your panel has room

    A licensed electrician checks that your service and panel can carry a new 50 A circuit (a load calculation) and that there is space for a two-pole breaker.

  2. Install a NEMA 14-50 receptacle on a dedicated 50 A circuit

    The electrician runs a dedicated circuit, typically 6 AWG copper, from a 50 A two-pole breaker to a NEMA 14-50 receptacle near where you park. Pull a permit where your jurisdiction requires one. Recent editions of the National Electrical Code require GFCI protection on 240 V receptacles in garages and outdoors; your electrician will advise what your local code requires.

  3. Mount the charger

    Fix the charger to the wall with the included mounting hardware, into studs or masonry, within reach of the receptacle and with the cable able to reach your charge port.

  4. Plug in and power up

    Plug the charger into the receptacle. The LCD lights and the charger runs its self-check.

  5. Connect your car and start charging

    Plug the J1772 connector into your car and press the side button (or start from the app). The display shows current, voltage, power and time while it charges.

  6. Stow the cable

    When you are done, press the button to stop, unplug the connector and hang the cable so it is off the floor and out of the way of the car.

What it usually costs

Installation cost depends on the distance from your panel to where you park and whether the panel has spare capacity. Ask two licensed electricians for a quote, and check whether your electric utility offers an installation rebate.